It looks like you're new here. If you want to get involved, click one of these buttons!
mm. 2, the door set after the three-dimensional horizontal, vertical tolerance tolerance of +2 mm, horizontal flatness tolerance allowed +1 mm; door sets and the combination of the wall should be fixed screws or gas nails (every meter a lot In 3); between the door and the wall gap with double-sided adhesive styrofoam, styrofoam should be coated evenly, dry after cutting smooth. Second, the line installation line installation should be uniform coating and door sets, wall
fixed, sets of line interface should be flat, tight, after installation side of the same line in a plane; due to wall is not flat, must ensure that line interface smooth. Sleeve tolerance allows tolerance of 1 mm. Third, the door installation 1, the door after the installation, should be flat, vertical, door and the door out of the flat face; door open no abnormal sound, flexible switch. 2, between the door and the gap between the door, the next seam is 6-8 mm, the remaining three
sides of 2.5 mm; all the allowable tolerance of +1 mm gap. 3, the door closed with a tight seal after the seal, do not swing. 4, hardware 1, door hinge should be vertical, flat; flat hinge should be in the door, the door corresponding to the slot, slot should be standardized, the same size and hinge, three allowable tolerance +0.5, after the formation of seamless , Hinge open should be flexible. The three-sided hinge is mounted in a mold and the plug should be inserted in
[url=http://pvcboardprice.com/pvc-board/1341.html]rigid foam sheets Kuwait[/url]
[url=http://compositedeckingforsale.com/wood-floor/14399.html]ultra deck hidden fasteners plastic[/url]
[url=http://floor-tec.co.uk/diy-floor/4793.html]plastic marine panel in malaysia[/url]